Volume 6, Issue 2 (Spring 2009 2009)                   IJMSE 2009, 6(2): 24-29 | Back to browse issues page

XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

M. Ardestani,, H. Razavizadeh,, H. Arabi, H. R. Rezaie. PREPARATION AND SINTERING OF W-20%Wt Cu COMPOSITE POWDERS PRODUCED BY CO-PRECIPITATION METHOD. IJMSE 2009; 6 (2) :24-29
URL: http://ijmse.iust.ac.ir/article-1-204-en.html
Abstract:   (39158 Views)

Abstract:

materials can be fabricated by sintering of W-Cu composite powders. In this research W-20%wt Cu composite powders

was synthesized via a co-precipitation method. Precipitate obtained from a mixture of copper nitrate and ammonium

paratungstate (APT) in distilled water contained W-Cu compounds. This precipitate was washed, dried and calcined

at 550

of dried precipitate powder was determined by thermogravimetry (TG), differential thermal analysis (DTA) and X-ray

diffraction (XRD). The sintering of the reduced powders was investigated as a function of temperature. Relative density

of more than 98% obtained for the powders sintered at 1200

close to theoretical calculations. The hardness of the sintered powders was 320 Vickers.

W-Cu composites are widely used as contacts, heat sinks and electro discharge electrodes. These kinds of°C in air and then reduced in H2 atmosphere in order to convert to W-Cu powders. The calcination temperature°C . The corresponding electrical conductivity was too
     
Type of Study: Technical Note | Subject: Ceramics

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb