Volume 17, Issue 2 (June 2020)                   IJMSE 2020, 17(2): 34-41 | Back to browse issues page


XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Azimi H. The Foaming Process of Poly Styrene-Co-Acrylonitrile (SAN) with Co Blowing Agents. IJMSE 2020; 17 (2) :34-41
URL: http://ijmse.iust.ac.ir/article-1-1586-en.html
Abstract:   (7207 Views)
In this work, the poly styrene-co-acrylonitrile (SAN)beads and three blowing agents (CO2, N2 and n-pentane) were used to investigate the foaming process via our batch foaming system. The solubility and diffusivity of three blowing agents were determined by the MSB. The solubility of blowing agents was increased by pressure and decreased by temperature increment. It was resulted that the solubility and diffusivity data for SAN/n-pentane/CO2 system (Using co-blowing gent) were higher than other samples. According to the scanning electron microscopy (SEM) results, it was concluded that the cell and foam densities were decreased with temperature increment and increased by pressure release rate in all foamed beads. With using co blowing agents, higher pressure release rate and low temperature without adding any fillers, we could improve the foam characteristics and produced the SAN foams with smaller cell sizes and greater cell and foam densities.
Full-Text [PDF 1293 kb]   (5382 Downloads)    
Type of Study: Research Paper | Subject: Ceramics

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb