Abstract: (39120 Views)
Abstract: Austenitic stainless steels exhibit a low hardness and weak tribological properties. The
wear behaviour of austenitic stainless steel AISI 316 was evaluated through the pin on disc
tribological method. For investigating the effect of wear on the changes in microstructure and
resistance to wear, optical microscopy and scanning electron microscope were used. The hardness
of the worn surfaces was measured with a micro-hardness tester. Worn surfaces were analyzed
through X-ray diffraction. Results showed that with increasing the sliding distance and applied
load, the austenite phase partially transformed to ά martensite, and there was no trace of ε phase
detected. Due to the formation of probably hard and strong martensite phase, as the sliding
distance and applied load increased, the hardness and the wear resistance of the material was
increased. Wear mechanism was on the base of delamination and abrasion.
Type of Study:
Research Paper |